MATERIAL SAFETY DATA SHEET

Product number: 01450056 and 01450055

Part number: 6950, 7020 & 7010

Processor:

Davison Oil Company, Inc.         Information: 251-633-4444
8450 Tanner Williams Rd.         Emergency: 800-535-5053
Mobile, AL 36608

HMIS RATINGS- Health: 1 Flammability: 1 Reactivity: 0 Personal Protection: B

U. S. TSCA INVENTORY: All components of this material are on the US TSCA inventory.

CAS NO.: 64742-52-5

CHEMICAL NAME AND SYNONYMS: Lubricating Oil

CHEMICAL FAMILY: Petroleum Hydrocarbon

PRINCIPLE HAZARDOUS COMPONENTS: None known

OSHA PEL / ACGIH TLV: 5 mg/m³ as mist See Section 6 (Carcinogenicity)

The following data are approximate or typical values and should not be used for precise design purposes.

Boiling Point, ⁰F 600+ 
% Volatile by Volume Negligible
Vapor Pressure (mmHg) <0.1 
Evaporation Rate (BUAC=1) <0.01
Vapor Density (Air=1) 1+ 
Solubility in Water Negligible
Melting Point: N/A 
Specific Gravity(D-287) API: 21.8 SP: .9225
Appearance and odor: Light to Dark amber color; hydrocarbon odor

Flammable Limits: LEL: ND     UEL: ND

Auto Ignition ND

Extinguishing Media: CO², water spray or fog, foam, dry chemical

Special Fire Fighting Procedures: Cool exposed containers with water spray, avoid breathing fumes.

Unusual Fire and Explosion Hazards: Pressure increase in over heated, closed containers. Cool containers with water spray.

STABILITY: stable 
HAZARDOUS POLYMERIZATION: Will Not Occur
CONDITIONS AND MATERIALS TO AVOID: Extreme heat
HAZARDOUS DECOMPOSITION PRODUCTS: Partial burning produces fumes, smoke, and carbon monoxide
INCOMPATIBILITY (Materials to avoid): Strong oxidants

PRIMARY ROUTE OF ENTRY: Dermal / Inhalation

EFFECTS OF OVEREXPOSURE: Prolonged or repeated liquid contact with the skin will dry and defat the skin, leading to irritation and dermatitis. Inhalation of fumes in high concentration may result in dizziness, headache, respiratory irritation or unconsciousness. The lethal oral dosage for a 150 pound human is approximately 1 pint to 1 quart.

CARCINOGENICITY: According to IARC Monographs severely hydrotreated lube oils, such as this product, are not considered carcinogenic. Nevertheless, good industrial hygiene practices are recommended.

First Aid Treatment: If overcome by fumes, remove from exposure immediately; call a physician. If breathing is irregular, or stopped, start resuscitation and administer oxygen. If ingested, DO NOT induce vomiting; call a physician. In case of skin contact, remove any contaminated clothing and wash skin with warm water and soap. If irritation persists, call a physician. If splashed into eyes, flush eyes with clear water for 15 minutes.

IN CASE OF SPILL OR LEAK: Remove ignition sources. Keep people away. Recover liquid. Add absorbent (sand, sawdust, etc.) to spill area. Minimize breathing of fumes. Ventilate confined spaces. Open all windows and doors. Advise authorities if product enters sewers, etc.

WASTE DISPOSAL METHOD: Assure conformity with applicable disposal regulations. Dispose of absorbed material at approved waste site.

EYE: Use goggles / face shield to avoid eye contact.
GLOVES: Use impervious gloves, if needed, to avoid repeated / prolonged skin contact.
RESPIRATORY: Normally not required. Respirator for mist.
OTHER CLOTHING / EQUIPMENT: As needed to prevent repeated / prolonged contact. If clothes become contaminated change to fresh, clean clothing; do not wear contaminated clothing until thoroughly laundered.
VENTILATION: LOCAL Face velocity greater than 60 cfm.     MECHANICAL No special requirement.

Keep containers closed when not in use. Do not handle or store near heat or flames.

OTHER PRECAUTIONS: Avoid breathing fumes. Wash skin thoroughly with soap / warm water after handling. Use chemical resistant gloves and apron.

ND = No Data NA= Not Applicable

The suggestions and data provided herewith are based upon tests and information which we believe to be reliable. However, users should make their own investigations to determine the suitability of the information or products for their particular purpose.